3-Ingredient
Fried Chicken:

Ingredients:

Items:	Quantity:
chicken legs, skin on, bone in	2
chicken thighs, skin on, bone in	2
all-purpose-flour	1 cup

*add about 1/4 tsp of salt & 1/2 tsp of black pepper to taste, and use vegetable oil for frying.

Steps:

1. Place your chicken pieces in a bowl after lightly salting each piece. Add enough water to just cover. Seal with a lid or clear wrap. Refrigerate overnight or at least for 4 hours.
2. Place the flour in a paper sack. Add your salt and pepper. I always taste a little to see if there's enough salt, but remember you brined your chicken in salt water so you don't want to over do it.
3. Add enough oil to come up about 1/3 to the sides of your pan. Heat on medium high until a pinch of flour begins to sizzle or the end of a wooden spoon placed in the hot oil sizzles, about 335 to 350 degrees. You do not want to cook your chicken in oil that is too hot because it will brown too quick and be raw in the middle.
4. While your oil is heating, remove the chicken from the water one piece at a time, allowing access water to fall off and add to the flour. Shake, shake, shake and turn until completely coated. Place on a sheet pan until all is coated.
5. When your oil is ready, add the chicken to the oil skin side down. Cook until the chicken is brown and crispy on that side, then turn. If your heat is too high, lower to medium high and add a lid and let it sit ajar. Cook, checking after about 10 minutes to see if the bottom has browned. When the bottom is brown, turn again, remove the lid and cook turning until the internal temperature reaches 165-170, raising the heat if needed. At this time you want to be close by, watching and turning as the chicken continues to brown on each side.
6. When done, drain on a wire rack and allow to rest for at least 10 to 15 minutes. If I am frying a large amount I will keep warm in my oven on the warm setting. Enjoy!